Siemens LMV5 Quick Start Manual page 11

Typical BMS system 1-3
Typical LMV51 BMS System
A typical LMV51 BMS system will include the following components :
LMV51.140xx Basic unit with load controller
AZL52.xxxx Display
SQM4x Actuator for Gas metering valve
SQM4x Actuator for Oil metering valve
SQM4x Actuator for Air damper
SQM4x Actuator for FGR (if equipped)
AGG5.210 Transformer (See CANbus Loading table, Section 3, Figure 3-1.4)
QRI2A2.B180B Forward viewing IR flame scanner
AGG2.110 Flame scanner adapter
AGG2.120 Conduit connector
Temperature Sensor and /or Pressure Sensor (both can be used for cold start)
AGG5.643 CANbus cable
AGG5.110 CANbus strain relief
AGG5.720 RAST 5 plug kit
AGG5.635 Pre-made CANbus cable for AZL
Flexible zero lash actuator shaft couplings
Actuator mounting brackets
Cord grips or liquid tight conduit adapters
Typical LMV52 BMS System
A typical LMV52 BMS system will include all of the components of the LMV51 system with the
exception of the LMV51.140xx base unit. The LMV52 unit can be used the same as a LMV51
BMS system is used, with the additional features disabled.
If the additional features are utilized, additional components typically include:
LMV52.240xx LMV52 required for O2 Trim or VSD (Replaces the LMV51.140xx)
O2 Trim:
PLL52.110A100 O2 trim module
QGO20.000D17 O2 Sensor
Depending on flue size:
AGO20.001A
AGO20.002A
RBF195M482-010-00-8HN31 Flue Gas (Stack ) PT-1000 sensor
QAC22
VSD: VSD unit (supplied separately)
AGG5.310 Closed loop VSD control kit (speed wheel and sensor
AGG5.210 Transformer (See CANbus Loading table, Section 3, Figure 3-1.4)
SQM4x Actuators for additional valves / dampers
AGG5.721 Extension Plug kit (VSD, additional actuators, transformer, etc.)
LMV5 QSG Rev 4
Flue Gas Collector (up to 16" Dia)
Flue Gas Collector (over 16" Dia)
Ambient temperature sensor
Sec 1 Pg 7 www.scccombustion.com