Connecting - Siemens SITRANS FUS060 Operating Instructions Manual

Connecting

This chapter describes how to wire up the device in two steps:
• Step 1: Wiring the transducer cables (Page 33)
• Step 2: Wiring output and power supply (Page 35).
• Step 3: Wiring PROFIBUS PA (Page 37)
2
Figure 5-1
Note
The connection of the transducers on the sensors type SONO 3100 and SONOKIT (both with
SONO 3200 transducers) or in the terminal housing of sensor type SONO 3300 is described
in the separate sensor operating instructions.
SITRANS FUS060 with PROFIBUS PA
Operating Instructions, 09/2021, A5E02225054-AD
1
①
Transducer cable entry (4 entries)
②
Terminal box lid for power supply and signal cables
③
Potential equalization (PE connector)
④
Output cable entry
⑤
Power supply entry
⑥
Terminal box lid for transducer / sensor cables
Overview electrical connections
3
4
5
1
6
5
31