Safety Notes; General Safety Instructions; Laws And Directives - Siemens SITRANS FUS060 Operating Instructions Manual

Safety notes

2.1

General safety instructions

Correct, reliable operation of the product requires proper transport, storage, positioning
and assembly as well as careful operation and maintenance.
Only qualified personnel should install or operate this instrument.
Note
Alterations to the product, including opening or improper modifications of the product are not
permitted.
If this requirement is not observed, the CE mark and the manufacturer's warranty will expire.
2.2

Laws and directives

General requirements
Installation of the equipment must comply with national regulations. For example EN 60079-14
for the European Community.
Instrument safety standards
The device has been tested at the factory, based on the safety requirements. In order to maintain
this condition over the expected life of the device the requirements described in these Operating
Instructions must be observed.
NOTICE
Material compatibility
Siemens Flow Instruments can provide assistance with the selection of wetted sensor parts.
However, the full responsibility for the selection rests with the customer and Siemens Flow
Instruments can take no responsibility for any failure due to material incompatibility.
SITRANS FUS060 with PROFIBUS PA
Operating Instructions, 09/2021, A5E02225054-AD
CAUTION
2
11