Siemens SITRANS FUS060 Operating Instructions Manual page 120

HMI menu structure
D.1 Menu items (FW Rev. 4.00.00)
Menu Device function,
code
Parameters
7.1.4.3. WET Flow 3
7
7.1.4.4 Track 4
7.1.4.4. Length 4
1
7.1.4.4. Angle 4
2
7.1.4.4. Displacement 4
3
7.1.4.4. Trig. con 4 Up
4
7.1.4.4. Trig. con 4 Dw
5
7.1.4.4. AUTO cal. 4
6
7.1.4.4. WET cal. 4
6
120
Description
This value represents the calculated
flow
Note: Only shown if WET is selected
in menu 7.1.1
Length of path 4 (m). The distance
between the two ultrasonic transduc‐
ers of path 4, see Figure 7-6 Sensor
geometry data (Page 70).
Angle of path 4
Displacement of path 4 (m)
Note: The value must be smaller than
the half entered pipe diameter (see
menu 7.1.3.2.2).
The signal trigger constant of the
fourth path up.
The signal trigger constant of the
fourth path down.
The AUTO calibration factor is auto‐
matically calculated
Note: Only shown if AUTO is selected
in menu 7.1.1
The WET calibration factor of the
path.
Note: Only shown if WET is selected
in menu 7.1.1
Factory setting Setting options
Depending on facto‐
ry calibration togeth‐
er with ordered sen‐
sor
Depending of sensor >0 to 8.0 m
size selected at order‐
ing
Depending of sensor 0 to 89°
size selected at order‐
ing
Depending of sensor 0 to 1.5 m
size selected at order‐
ing
SONO 3100 and SO‐ -1.40 to +1.40
NOKIT:
-0.75
SONO 3100 (special
applications):
Depending on the or‐
dered system
SONO 3300:
Depending on the or‐
dered sensor
SONO 3100 and SO‐ -1.40 to +1.40
NOKIT:
-0.75
SONO 3100 (special
applications):
Depending on the or‐
dered system
SONO 3300:
Depending on the or‐
dered sensor
Depending on facto‐ 0.0000010 to
ry calibration of the 100.0000000
transmitter, which is (value with 7 frac‐
typically done to‐ tional digits)
gether with the or‐
dered sensor
SITRANS FUS060 with PROFIBUS PA
Operating Instructions, 09/2021, A5E02225054-AD
Read
or write
Read
Write
Write
Write
Write
Write
Read
Write