Canon imageRUNNER ADVANCE 8105 Series Manual page 211

7) Reverse the steps from step 5) to install the parts.
8) Place the originals on the document tray and scan or copy to make sure that the symptom is improved. If
the symptom is improved, the work is completed. If an original feed fault or multi feed occurs, proceed to the
following step.
a) If original feed fault occurs:
The torque limiter prepared this time (FE3-4556-000) has an original multi feed prevention feature (for
applying force to return the original(s)) which is too strong. Thus, prepare the red marked torque limiter
(FC8-5907-000) and the arm sensing sheet set (FM4-9078-000), and proceed to step 9). The blue marked
torque limiter (FC7-2494-000) having low separation performance is fitted on the feeder with a serial number
earlier than the following serial numbers. Be sure to prepare the red marked torque limiter.
b) If multi feed occurs:
With the replaced torque limiter (FE3-4556-000) installed, prepare the arm sensing sheet set
(FM4-9078-000) and proceed to step 9).
9) In Settings/Registration > Function Settings > Common > Scan Settings > Timing to Raise Feeder Tray,
select "When Panel Is Touched" and press "OK" button to close the setting screen.
10) Place originals on the original pickup tray and touch a given key on the control panel to lift the original
pickup tray [1].
Model
Duplex Color Image Reader-C1(INCH/A)
Duplex Color Image Reader-C1(A)
Duplex Color Image Reader-C1(INCH/AB) GAU00001
Color Image Reader-C1(INCH/A)
Color Image Reader-C1(INCH/A)
Color Image Reader-C1(INCH/AB)
Color Image Reader-C1(INCH/AB)
Serial #
GAQ00001
GAR00001
GAL00004
HTZ10000
GAN00001
HUA10000
pg. 211