Table of Contents
Advertisement
Furthermore, make sure that the bracket plate [6] is installed so that its end [g] is positioned along the
marking-off line [h], as shown in the photo below. If the bracket plate is not positioned as described above,
loosen the screw [7] once. Then, place the end of the bracket plate along the marking-off line so that
tension is applied to the belt appropriately. Then, tighten the screw.
5-2) At the same time, make sure that the teeth of the gear [8] are engaged with the belt [9] as shown in
the photo below. The gear is located behind the bracket plate [6].
pg. 147
Hide quick links:
Advertisement
Table of Contents
