Setting Up The Printer To Fax - Lexmark MX432 User Manual

Set up, install, and configure
Adjusting the default internal speaker volume
1
From the home screen, touch
2
Adjust the volume.
Notes:
•
If Quiet Mode is enabled, then audible alerts are turned off. This setting also slows the printer
performance.
•
The volume resets to the default value after the user exits Accessibility mode or when the printer wakes
from Sleep or Hibernate mode.
Enabling spoken passwords or personal identification numbers
1
From the home screen, touch Settings > Device > Accessibility > Speak Passwords/PINs.
2
Enable the setting.

Setting up the printer to fax

Supported fax
Printer model
MX432adwe
XM3142
1
Needs a subscription. For more information, go to
you purchased the printer.
2
Needs an installed license bundle. For more information, contact the place where you purchased the printer.
Setting up the fax function using analog fax
Notes:
•
Some connection methods are applicable only in some countries or regions.
•
If the fax function is enabled and not fully set up, then the indicator light may blink red.
•
If you do not have a TCP/IP environment, then use the control panel to set up fax.
Warning—Potential Damage: To avoid loss of data or printer malfunction, do not touch cables or the printer
in the area shown while actively sending or receiving a fax.
.
Analog fax
etherFAX
1 Fax server
https://www.etherfax.net/lexmark
Fax over IP (FoIP)
or contact the place where
29
2