Set up, install, and configure
For more information on navigating a magnified screen, see
24.
Adjusting the Voice Guidance speech rate
1
From the home screen, touch Settings > Device > Accessibility > Speech Rate.
2
Select the speech rate.
Adjusting the default headphone volume
1
From the home screen, touch Settings > Device > Accessibility.
2
Adjust the headphone volume.
Note: The volume resets to the default value after the user exits Accessibility mode or when the printer
wakes from Sleep or Hibernate mode.
Adjusting the default internal speaker volume
1
From the home screen, touch
2
Adjust the volume.
Notes:
•
If Quiet Mode is enabled, then audible alerts are turned off. This setting also slows the printer
performance.
•
The volume resets to the default value after the user exits Accessibility mode or when the printer wakes
from Sleep or Hibernate mode.
Enabling spoken passwords or personal identification numbers
1
From the home screen, touch Settings > Device > Accessibility > Speak Passwords/PINs.
2
Enable the setting.
Setting up the printer to fax
Setting up the fax function using analog fax
Notes:
•
Some connection methods are applicable only in some countries or regions.
•
If the fax function is enabled and not fully set up, then the indicator light may blink red.
•
If you do not have a TCP/IP environment, then use the control panel to set up fax.
Warning—Potential Damage: To avoid loss of data or printer malfunction, do not touch cables or the printer
in the area shown while actively sending or receiving a fax.
.
"Navigating the screen using gestures" on page
26