Advertisement
Adjustment Procedures
1. Adjust the white balance.
WHITE button/MSU-700 → ON (lit)
2. Make a lines selection at the center white portion of
the grayscale chart.
3. MSU menu operation:
. PAINT button → ON (lit)
. Touch panel operation
(Page 1/3) → [Detail] → [Detail|2]
Adjustment Item: Frequency
Specification:
The edge width at each end of the
center white portion shall be equal.
Note
After adjustments are complete, be sure to perform Section
4-7-9 "H/V Ratio Adjustment".
HDC-750A
4-7-14. Detail Clip Adjustment
Equipment: Analog waveform monitor
Test Points: G/Y OUT (pin 4), G/Y GND (pin 3)/
Object:
Note
Perform this adjustment to suit the customer's preferences
if required.
Line select
Preparations
. Setting for MSU-700
KNEE OFF button → OFF (lit)
DETAIL OFF button → ON (dark)
. Connect the waveform monitor to the VTR connector of
the camera adaptor.
. Shoot the grayscale chart so that the chart frame is
aligned with the underscanned monitor frame.
. Iris of the lens: A = 600 ± 20 mV (terminated with 75 Z)
Adjustment Procedures
1. Adjust the white balance.
WHITE button/MSU-700 → ON (lit)
2. Make a lines selection at the center white portion of
the grayscale chart.
4-7. Overall Video Adjustment
VTR connector
Grayscale chart
A
Line select
4-23 (E)
Advertisement
