Advertisement
2-5. Disconnecting/Connecting Flexible
Card Wire
The two flexible card wires are used between the MB-570
board and PA-173 board, MB-570 board and DR-264
board. Take care not to bend forcedly these flexible card
wires. This shorten the wire life.
Disconnecting
1. Turn off the power.
2. Slide portions A in the direction of the arrow to unlock
and pull out the flexible card wire.
Connecting
m
. Be careful not to insert the flexible card wire obliquely.
. Check that the conductive surface of the flexible card
wire is not soiled with dust.
1. Slide portions A in the direction of the arrow and
insert the flexible card wire as far as it will go with the
conductive surface down.
2. Slide portions A in the reverse direction to lock.
A
Conductive surface
HDC-750A
2-6. Positioning Adjustment for Filter
Installing the filter knobs, be sure to perform the following
adjustment.
1. Rotate the outer knob shaft until the cross filter can be
2. Align the CC filter knob number A with the mark on
3. Rotate the CC filter knob and check that it moves
4. Rotate the inner knob shaft until the clear filter
5. Align the ND filter knob number 1 with the mark on
6. Rotate the ND filter knob and check that it moves
A
2-5. Disconnecting/Connecting Flexible Card Wire
2-6. Positioning Adjustment for Filter Knobs
Knobs
seen from the lens mount.
the front panel and tighten the two setscrews.
Tightening torque: 20 x 10
smoothly.
(straight through filter) can be seen from the lens
mount.
the front panel and tighten the two setscrews.
Tightening torque: 20 x 10
smoothly.
Setscrews
(WP2 x 3)
Setscrews
(WP2 x 3)
_2
N.m (2.0 kgf.cm)
_2
N.m (2.0 kgf.cm)
Mark
2-5 (E)
Advertisement
