Advertisement
3-1. Setup Menu
3-1-6. SYS Config Menu
3-1-6. SYS Config Menu
The SYS Config menu is used to set operating mode of the tally lamps or to make adjustments of limited
service.
To activate the SYS Config menu, first display the TOP menu.
Page
Ver.
Item
Tally
Own Call
F Tally RVS
(Back Tally)
R Tally
G Tally
Up Tally Level
Filter CTRL
Pixel
Auto
REF DC
Manual R
Manual G
Manual B
APR at ABB
h) Rear tally lamp refers to back tally lamp (of HDCA-750A) and VF tally lamp (of HDVF-20 or HKCA-700).
k) Front tally lamp refers to up tally lamp (of HKCA-700).
3-16 (E)
Settings
Contents
R, F&R , Off
Selects whether tally lamps are lit or not, or which tally lamp is
lit when the CALL switch on the camera adaptor is pressed
(This setting is valid only when the HDCU is connected to the
camera
When the camera is used alone without being connected to
RCP/MSU, this setting is turned off regardless of the menu
indication )
R:
F&R: Both rear
OFF: No tally lamp is lit
[On], Off
Tally lamps stay lit while the tally signal is input from the
HDCU or VTR
This item selects the operating mode of the tally lamps when a
CALL button of MSU or RCP is pressed while lit
On:
Off:
[On], Off
Turns on and off the function to light up the back tally lamp
when the R tally singal is input
[On], Off
Turns on and off the function to light up the back tally lamp
when the G tally singal is input
0 to 10 ([5])
Sets the intensity of the up tally lamp
(Does not function in this unit )
[Lock], Unlock
Lock:
Unlock: ND/CC filter can be selected even though the R tally
Press MENU SEL switch
Starts to automatically correct RPN (Activates APR function)
to execute
00 to FF ([80])
Sets the APR detection level
Press MENU SEL switch
Enters a manual correction mode for RPN
to execute
On, [Off]
Turns on and off the function to activate the APR each time
the black balance is automatically performed
One or two rear tally lamps
h)
are lit
h)
and front
k)
tally lamps are lit
h)
k)
Both rear
and front
tally lamps go out
h)
Rear
tally lamps alone go out
ND/CC filter cannot be selected when the R tally
signal is input
signal is input
HDC-750A
Advertisement
