Advertisement
3-1. Setup Menu
3-1-3. Maintenance Menu
Page
Ver.
Item
Camera Setup
H Phase
FREQ SEL
Fan Mode
Link Tally
BATT Type
Alarm VOLT
SDI/VTR Setup
Prompter
Serial Output
Optical
Cable COMP
Output Signal
CN Output
Date/Time
DD/MM/YY
HH:MM
Area SEL
Timer
Camera ID
Camera ID
f) If "RED" is indicated, be sure to clean the optical connector or optical connector cable. If "YEW" is indicated, cleaning them is
recommended. For details on how to clean, refer to the maintenance manual supplied with the camera adaptor.
3-12 (E)
Settings
Contents
_100 to 100 ([0])
Adjusts the H phase
60, [59.94] Hz
Selects the field frequency
[Auto1], Auto2, MIN, Off
Auto1: Normal mode
Auto2: Silent mode
MIN:
Off:
On, [Off]
On:
Off:
[Lithium], Others,
Select according to a battery in use
CCU, Anton, BP-90
This setting enables the battery alarm voltage indication
corresponding to the battery characteristics
10.0 to 13.0 V ([10.0])
Sets the battery alarm voltage (Stores the voltages for every
battery)
On, [Off]
On:
Off:
On, [Off]
On:
Off:
Displays a photo-receptive condition of the optical connector
of camera adaptor
(Corresponds to the indicator on DPR-77 board of HDCU )
___:
GRN:
YEW: Normal (_17 to _20 dBm
RED:
NG:
*
0dBm = 1 mW
On, [Off]
Turns on and off the VTR (26P) cable compensation
RGB, [YPbPr]
Selects the main signal to be output to a VTR
[Main], RET
Sets the VTR connector
Adjusts a built-in calendar and timer
GMT_12 to +12 (+[9])
Sets the standard time in various countries
Indicates the power-on time of the unit
Sets a camera ID of up to ten alphanumerics, symbols, and
spaces
Minimum turn mode
Forcibly turned off
The unit enters the above-mentioned MIN mode with
a tally signal input
The mode determined by the above setting is valid all
the time
Prompter signal is output at GLK/PROMPT connector
of the camera adaptor
(This setting is valid only when HDCU is connected )
No prompter signal is output
SDI signal is output at SERIAL OUT connector of
camera adaptor
No SDI signal is output
(This setting is valid only when the camera is used
alone )
When the camera is used alone
*
Normal (_17 dBm
or more)
*
)
Abnormal (less than _20 dBm
Out of sync with HDCU
f)
*
)
HDC-750A
Advertisement
