Advertisement
Page
Ver.
Item
Detail 2
Detail
W.Limiter
B.Limiter
K.AP.Gain
Knee APERT
Knee APERT
Clear
Skin Detail
Skin Detail
Level
Phase
Width
Saturation
Gate
Clear
Matrix
R-G, R-B
G-R, G-B
B-R, B-G
Matrix
User MTX
Preset MTX
PRE MTX SEL
Test
Clear
HDC-750A
http://getMANUAL.com
Settings
Contents
[On], Off
Turns on and off the function to improve resolution by adding the
detail signal
_99 to 99 ([0])
Adjusts the clipping level against the higher detail signal at the
maximum level
_99 to 99 ([0])
Adjusts the clipping level against the lower detail signal at the
minimum level
_99 to 99 ([50])
Adjusts the knee aperture gain
_99 to 99 ([0])
Adjusts the knee aperture level
On, [Off]
Turns the knee aperture function on and off
Press MENU SEL switch
Resets numeric settings on the Detail 2 page to 0
to execute
(When you press MENU SEL switch, the "Clear" indication flashes.
Press MENU SEL switch again to execute; press CANCEL button
to cancel)
On, [Off]
Turns the skin detail function on and off
_99 to 99 ([0])
Adjusts the level of the skin detail
0 to 359 (DEG) ([0])
Adjusts the hue for the skin detail function
0 to 90 (DEG) ([0])
Adjusts the color width for the skin detail function
_99 to 99 ([0])
Adjusts the color saturation for the skin detail function
On, [Off]
Turns on and off the area display for the skin detail on the
viewfinder screen
Press MENU SEL switch
Resets numeric settings on the Skin Detail page to 0
to execute
(When you press MENU SEL switch, the "Clear" indication flashes.
Press MENU SEL switch again to execute; press CANCEL button
to cancel)
_99 to 99 ([0])
Sets an optional value as the constant of the liner matrix for R-G,
R-B, G-R, G-B, B-R and B-G (Compensates the user's matrix )
_99 to 99 ([0])
_99 to 99 ([0])
On, [Off]
Turns the matrix compensation on and off
On, [Off]
Turns the user's matrix compensation on and off
[On], Off
Turns the preset linear matrix (fixed constant compensation) on
and off
[SMPTE-240M]
Selects the preset linear matrix (fixed constant compensation)
REC-709
SMPTE-WIDE
NTSC
EBU
[Off], 1, 2
Selects the TEST signal
Off: No test signal is output
1:
2:
Press MENU SEL switch
Resets numeric settings on the Matrix page to 0
to execute
(When you press MENU SEL switch, the "Clear" indication flashes.
Press MENU SEL switch again to execute; press CANCEL button
to cancel)
Outputs the sawtooth waveform test signal
Outputs the 3-step waveform test signal
3-1. Setup Menu
3-1-2. Paint Menu
3-9 (E)
Advertisement
