Advertisement
2-8-3. Driver board
1. Remove the right side panel referring to Section 2-3.
2. Remove the connector and two screws to remove the
driver board.
Connector
Driver board
3. Install a new board in the reverse order of removal.
4. After replacing the board, be sure to perform adjust-
ment referring to Sections 2-10-3 and 4.
HDC-750A
http://getMANUAL.com
B2.6 x 5
Right side panel
2-9. Replacement of DC/DC Converter Unit
2-9. Replacement of DC/DC Converter
Unit
The unit is provided with the two types of DC/DC convert-
er units.
1. Remove the CCD unit referring to Section 2-7.
2. Remove the three screws to remove the handle.
B4 x 20
B5 x 12
3. Remove the three screws. Disconnect the connector
from the SW-806 board and remove the handle holder.
Handle holder
Connector
B3 x 5
2-8. Replacement of Filter Disk Unit
B4 x 20
Handle
B2.6 x 16
SW-806
2-9 (E)
Advertisement
