Advertisement
2-12. Replacement of Connector ..................................................................2-14 (E)
2-13. Replacement of Function Switches .....................................................2-16 (E)
2-14. Periodic Replacement Part ..................................................................2-18 (E)
2-15. Cleaning of Dustproof Filter ...............................................................2-19 (E)
2-16. Cares After Using at Special Environment .........................................2-19 (E)
2-17. Note on Replacement of Lithium Battery ...........................................2-19 (E)
3. Setup Menu
3-1.
Setup Menu ...........................................................................................3-1 (E)
4. Electrical Alignment
4-1.
Preparation ............................................................................................4-1 (E)
4-2.
Filter Drive Board Adjustment ..............................................................4-3 (E)
4-3.
VA-158 Board Adjustment ...................................................................4-4 (E)
4-4.
MX-59 Board Adjustment .....................................................................4-6 (E)
2 (E)
2-12-1. 68-pin Connector ................................................................2-14 (E)
2-12-2. VF Connector .....................................................................2-14 (E)
2-12-3. MIC Connector ...................................................................2-14 (E)
2-12-4. TEST OUT Connector .......................................................2-15 (E)
2-13-1. On the Side Switch Panel ...................................................2-16 (E)
2-13-2. On the Front Switch Panel .................................................2-16 (E)
2-13-3. On the Top Panel ................................................................2-17 (E)
3-1-1.
Operation Menu ................................................................... 3-3 (E)
3-1-2.
Paint Menu ...........................................................................3-7 (E)
3-1-3.
Maintenance Menu .............................................................3-11 (E)
3-1-4.
File Menu ...........................................................................3-14 (E)
3-1-5.
Diag Disp Menu .................................................................3-15 (E)
3-1-6.
SYS Config Menu ..............................................................3-16 (E)
4-1-1.
Equipment Required .............................................................4-1 (E)
4-1-2.
Notes on Adjustment ............................................................4-1 (E)
4-1-3.
Connection ........................................................................... 4-2 (E)
4-1-4.
Initial Settings ...................................................................... 4-3 (E)
4-2-1.
Filter Positioning Adjustment ..............................................4-3 (E)
4-3-1.
TEST SAW Level Adjustment .............................................4-4 (E)
4-3-2.
VA Gain Adjustment ............................................................4-5 (E)
4-4-1.
FLARE PRESET Adjustment ..............................................4-6 (E)
4-4-2.
RGB Level Adjustment ........................................................4-7 (E)
4-4-3.
Knee Aperture Crispening Adjustment ................................4-7 (E)
4-4-4.
Knee Aperture Balance Adjustment ..................................... 4-8 (E)
4-4-5.
Pedestal Level Adjustment ................................................... 4-8 (E)
HDC-750A
Advertisement
