Advertisement
4-1-4. Initial Settings
HDC-750A
. Side panel (upper side)
Y/RGB switch → Y
. Make the following settings using the setup menu.
MENU: Maintenance
PAGE: SDI/VTR Setup
ITEM: Cable COMP → Off
MSU-700 Operation Panel
. CAM POWER/Signal output select buttons
ALL button
CAM PW button
VF PW button
TEST 1 button
TEST 2 button
BARS button
CLOSE button
. CAM/CCU Function ON/OFF buttons
KNEE OFF button
DETAIL OFF button
LVL DEP OFF button
MATRIX OFF button
AUTO KNEE button
SKIN DETAIL button
. Others
GAMMA OFF button
MASTER GAIN button
FILTER button (ND)
FILTER button (CC)
ECS/SHUTTER ON button
HDC-750A
→ OFF (dark)
→ ON (lit)
→ ON (lit)
→ OFF (dark)
→ OFF (dark)
→ OFF (dark)
→ ON (lit)
→ OFF (lit)
→ OFF (lit)
→ OFF (lit)
→ OFF (lit)
→ OFF (dark)
→ OFF (dark)
→ ON (dark)
→ 0 (0 dB)
→ 1 (lit)
→ B (lit)
→ OFF (dark)
4-2. Filter Drive Board Adjustment
4-2-1. Filter Positioning Adjustment
Note
. This adjustment is required only when replacing the
CCD unit or the filter drive board.
Preparation
. S1/Filter drive board → REMOTE (upper side)
Adjustment Procedures
1. ND 1 button/MSU-700 → ON
2. Adjust 1RV1 so that the ND 1 filter stops at a proper
click position (on the optical axis of the lens) observ-
ing from the lens mount.
3. Adjust positions for other filters in the same manner.
Filter
Adjustment Point
ND1 (clear)
1RV1
ND2 (1/4 ND)
1RV2
1RV3
ND3 (1/16 ND)
ND4 (1/64 ND)
1RV4
CC1 (cross)
1RV5
CC2 (clear)
1RV6
CC3 (4300 K)
1RV7
CC4 (5600 K)
1RV8
REMOTE
S1
LOCAL
RV3 RV1
RV4 RV2
DRIVER BOARD (A SIDE)
4-1. Preparation
4-2. Filter Drive Board Adjustment
RV8 RV6
RV7 RV5
4-3 (E)
Advertisement
