Advertisement
2-12. Replacement of Connector
2-12. Replacement of Connector
2-12-1. 68-pin Connector
1. Remove the two DC/DC converter units carrying out
procedures 1 to 7 in Section 2-9 "Replacement of DC/
DC converter unit".
2. Remove the two screws.
3. Remove the two screws securing the CN-1034 board.
Disconnect the two connectors and two flexible card
wires.
n
Refer to Section 2-5 before disconnecting or connect-
ing the flexible card wire.
Flexible card wires
CN-1034
Connectors
4. Replace the CN-1034 board with the connector
mounted. Install a new connector in the reverse order
of removal.
2-14 (E)
2-12-2. VF Connector
1. Remove the CCD unit referring to Section 2-7.
2. Remove the two screws to pull out the VF connector.
Precision
P2.6 x 5
3. Install a new connector in the reverse order of remov-
2-12-3. MIC Connector
1. Remove the two screws to pull out the MIC connector.
Precision
P2 x 5
2. Install a new connector in the reverse order of remov-
Desolder the VF connector.
VF connector
Precision
P2.6 x 5
al.
Desolder the MIC connector.
MIC connector
al.
Precision
P2.6 x 5
HDC-750A
Advertisement
