Advertisement
2-11. Replacement of Fan
c
If the fan is out of order, the inside temperature of the unit
will rise. Touching the inside in this state may cause a
burn. When replacing the fan, allow a few minute after
powering off until the inside cools off.
1. Perform the procedures 1 to 3 in Section 2-7-2 to
remove the CCD unit.
2. Remove the seven screws to remove the V shoe
bracket.
V shoe bracket
3. Remove the two screws. Disconnect the harness from
the SW-688 board.
HDC-750A
4. Remove the four screws to remove the fan.
5. Install a new fan in the reverse order of removal.
[Notes|at|installation]
[Notes|at|installation]
[Notes|at|installation]
[Notes|at|installation]
[Notes|at|installation]
B3 x 5
. Install the fan to the bracket with care so that the label
faces the bracket and the fan harness is routed as shown
in the above figure.
. Insure a proper fit between the fan bracket and chassis as
shown in the figure below.
K3 x 8
B3 x 5
B2.6 x 4
Fan
B2.6 x 20
Harness
B2.6 x 20
Label
Bracket
Fan bracket
Fan bracket
2-11. Replacement of Fan
2-13 (E)
Advertisement
