Table of Contents
Advertisement
DPX-530
FUNCTION MENU (SETTING MENU ONLY FOR SERVICE)
Displaying the FUNCTION menu
1. Select "LANGUAGE" in the INITIAL menu.
2. Press the "AUTO," "ENTER," and "AUTO" buttons on the remote control in order. The FUNCTION menu will be
displayed.
Exiting the FUNCTION menu
Press the "MENU" button while the FUNCTION menu is displayed.
Note: The menu is not initialized by selecting "RESET ALL" in the INITIAL menu. To initialize the menu, press the
"MENU," "ENTER," and "
Item
Setting range
WHITE, BLACK,
CROSSHATCH,
TEST SIGNAL
RED, GREEN,
BLUE, YELLOW,
CYAN, MAGENTA
A/D LEVEL
DEC LEVEL
Y/C DELAY
0 ~ 0359
C/W DELAY
MODE DISPLAY
ON, OFF
STRAIGHT
ON
GAMMA
REMOTE POS. AUTO, FRONT, REAR
WARNING
1 MIN, NO LIMIT
Notes in displaying the FUNCTION menu
When you press the "AUTO", "ENTER" and "AUTO" buttons with other selection than "LANGUAGE" in the INITIAL
menu, the FUNCTION menu isn't displayed.
If you continue setting without displaying the FUNCTION menu, you may not be able to display the menus such as the
INITIAL menu and the SET UP menu by the "
control or that of the projector to exit the current menu, and open the menu again.
Notes in using the FUNCTION menu
- If you change the settings of the WARNING menu after the lamp operating time exceeds 1500 hours, the warning
indication may stay on the screen. In such a case, turn off the power to cancel the warning indication.
- When a test pattern is displayed with [VIDEO] or [S-VIDEO] selected as the input source, subsequent images may not
be displayed correctly. In such cases, select [Computer] as the input source.
26
G
" buttons on the projector at the same time.
To display the test patterns.
(The ENTER button displays the test pattern.
Pressing any button cancels the displayed
test pattern.)
To adjust the input gain of A/D to improve solid white
±5
in the image (or too dark image) when the amplitude
of the video signal of the computer is large (or small).
To adjust the input gain of DECODER to improve
±5
solid white in the image (or too dark image) when
the amplitude of the video signal is large (or small).
To adjust the amount of DELAY of Y and C of
±3
the VIDEO signal (which is input to the
S-VIDEO and VIDEO terminal).
This item is used when the CW unit is replaced.
Do not change the setting value normally because
it has been uniquely set for each projector.
Improper change will cause incorrect colors.
To select whether or not to indicate the
switched input terminal in the upper right-hand
corner of the screen at the time of switching
the input terminal while the power is on.
Not used normally. To make the gamma
setting linear.
To select the remote control sensor to be
enabled.
To set the time over which the alert for the
lamp replacement is displayed.
H
" or "
Function
Max.=+10%
Min. =–10%
(every 2%)
Max.=+10%
Min. =–10%
(every 2%)
Max.=+111 ns
Min.=–111 ns
(every 37 ns)
ON: With indication
OFF: Without indication
Pressing the ENTER button
makes the gamma setting linear.
AUTO: Both of FRONT and REAR sensors
FRONT: Front sensor only
REAR: Rear sensor only
1 MIN: 1 minute
NO LIMIT: No time limit (After the alert is
displayed for one minute, you can cancel it
by any button or the RS-232C command.)
G
" button. In such cases, press the "MENU" button on the remote
Default
Last
setting
memory
OFF
No
0
Yes
0
Yes
0
Yes
Unique
Yes
value
ON
Yes
No
AUTO
Yes
1 MIN
Yes
Advertisement
Table of Contents
