Table of Contents
Advertisement
DPX-530
LEAD DRESS
Note:
The inner wires are clamped so that they do not come close to heat generating or high voltage parts. After
servicing route all wires in their original position.
1. Clamp the lead wires along the Clamping Zone* shown in the figure below.
*Clamping Zone shows the route of the lead wire.
Routing in the chassis ASS'Y 1
Run the SD lead.
AM
IRF PCB ASS'Y
Stopper
Fit the lug of the ground
wire to the stopper.
22
SA
SD
Lead barrier
CN2
Lamp power unit
Run the RE-CN2
lead.
Twist the TD lead at
least 7 times and tuck
it at the back of the
RD connector.
CN1
PB
RD
POWER PCB ASS'Y
RE
TD
RD
Fig. 3-1
INLET PCB ASS'Y
Twist the SN lead at
least 7 times and
SN
clamp it with a tape.
SX
Clamp the SX lead with a tape.
Advertisement
Table of Contents
