Managing Ties; To Create A Tie; To Remove A Tie - Extron electronics SMX Series User Manual

Managing ties

Using the SMX Control window, you can create, remove, and view input-to-output
ties.

To create a tie

Click and drag an input box outline over to an output box.
• If Hold/Verify Changes has been selected in the Preferences menu, a
broken line connecting the two boxes appears, indicating a pending tie.
N If you want to undo the pending tie, click Cancel. The broken line disappears.
Click Take to confirm the tie. The broken line becomes solid.
Figure 5–8 — Completed ties (solid) and pending ties (broken lines)
• If Immediate Changes has been selected in the Preferences menu, the tie is
made immediately, a solid line appears and Cancel or Take buttons are not
displayed.

To remove a tie

Drag the output box outline to its tied input box or to the trash can.
• If Hold/Verify Changes has been selected from the Preferences menu, the
(solid) tie line becomes broken.
N If you want to reinstate the tie, click Cancel. The line becomes solid.
Click Take to remove the tie. The broken tie line disappears.
• If Immediate Changes has been selected from the Preferences menu, the tie is
removed immediately.
SMX System MultiMatrix Switchers • SMX Control Software
5-17