Installing Cisco Hsi - Cisco Signaling Interface H.323 User Manual

Chapter 2 Installing and Configuring Cisco HSI Software

Installing Cisco HSI

This section provides step-by-step instructions for installing a single Cisco HSI for use with a simplex
PGW 2200 configuration (a configuration with one Cisco PGW 2200 host). To install a dual Cisco HSI
for use with a redundant PGW 2200 configuration (a configuration with two Cisco PGW 2200 hosts),
complete the steps in this section and then proceed to the
PGW 2200 Configuration" section on page
In the following installation procedure, the package name is OTTgw000 and the version of the software
Note
is 4.1; the /export/BUILDS directory is used to install the system software.
To install the Cisco HSI, complete the following steps:
Verify that the operating system is installed. See the
Step 1
page 2-1
Login as root.
Step 2
Issue the command: cd /export
Step 3
Step 4 The initial step for downloading the HSI software depends upon the media from which you obtain the
software:
•
•
OL-4806-01 Rev. A14
for more information.
If you download the software from a server, it will be in a tar file. Issue the following command:
# tar xvf GoldWing-4.1.tar
This command displays the following text:
x ./4.1/APPLICATIONS, 0 bytes, 0 tape blocks
x ./4.1/APPLICATIONS/OTTgw000.pkg, 38954496 bytes, 76083 tape blocks
x ./4.1/install.sh, 5223 bytes, 11 tape blocks
x ./4.1/uninstall.sh, 3053 bytes, 6 tape blocks
The byte and block counts for your installation may be different from those provided in the
Note
preceding example.
If you download the software from a CD-ROM, insert the Cisco HSI 4.1 CD-ROM into the drive and
issue the following commands:
# mkdir BUILDS/4.1
# cp -r /cdrom/hsi_4.1* /* /export/BUILDS/4.1
"Installing Multiple Cisco HSIs in a Redundant
2-10.
"Installing the Operating System" section on
Cisco H.323 Signaling Interface User Guide
Installing the Cisco HSI
2-5