Cisco Signaling Interface H.323 User Manual page 60

H.323 Stack Configuration
Table 3-14 Common Static System Data Parameters
Parameter Name
CarrierCodeMapping
ClipClirSupported
DtmfSupportedType
DtmfSupportedDirection
H225PavoSupported
RaiSupported
Cisco H.323 Signaling Interface User Guide
3-20
Parameter Values
"enabled"—a string that indicates the
•
feature is enabled.
Blank ("")—indicates the feature is
•
disabled.
"deleted"—indicates that the feature
•
is disabled.
"enabled"—a string that indicates the
•
feature is enabled.
Blank ("")—indicates the feature is
•
disabled
"deleted"—indicates that the feature
•
is disabled
"dtmf"—the recommended value for
•
interworking with Cisco gateways
• "basicString"
"tx"—transmit to H323 endpoint
•
• "rx"—receive from H.323 endpoint
"both"—transmit and receive DTMF
•
• Blank (""), "deleted," or any other
string, such as "disabled"—indicates
the feature is disabled
• "enabled"—a string that indicates the
feature is enabled.
Blank ("")—indicates the feature is
•
disabled
"deleted"—indicates that the feature
•
is disabled
For example:
• "enabled"—a string that indicates the
feature is enabled.
Blank ("")—indicates the feature is
•
disabled
"deleted"—indicates that the feature
•
is disabled
Chapter 3
Description
Allows the mapping of a special tech prefix (the
format of which is CCxCy) to the
DestinationCircuitID "group" field in the ARQ
message. This feature works only with IOS
Gatekeeper build Release 12.2(15)T10 or above.
Allows transit of CLI presentation/screening
information.
Setting this parameter to "enabled"
Note
enables use of Caller ID.
Selects the DTMF type during H.245 terminal
capabilities exchange.
Note Set this parameter to "dtmf" and the
DtmfSupportedDirection parameter to
"both" to enable DTMF support.
Selects DTMF transit direction.
Note Set this parameter to "both" and the
DtmfSupportedType parameter to "dtmf"
to enable DTMF support.
Allows transit of redirecting number parameter
(contained in Cisco CallManager H.225 setup
messages—nonStandardControl field).
Allows H.225 RAS RAI messages to be sent to the
gatekeeper if the E-ISUP link fails or if the HSI is
under heavy load.
Set this parameter to "enabled" to enable
Note
the HSI to support RAI messages.
Provisioning the Cisco HSI
OL-4806-01 Rev. A14