Cisco Signaling Interface H.323 User Manual page 33

Chapter 2 Installing and Configuring Cisco HSI Software
Step 14 Type the gatekeeper ID (see
Note
The following text displays:
Enter E-ISUP Host Port
Type the E-ISUP host port (see
Step 15
Note
The following text displays:
Enter VSC1 Name
Step 16 Type the VSC1 name and press Enter.
Note
The following text displays:
Enter VSC1 Port
Type the VSC1 port number (see
Step 17
Note
The following text displays:
Enter Installation NodeId
Type the installation node ID (see
Step 18
Note
The following text displays:
Enter Hardware Platform
Type the hardware platform name (see
Step 19
name). The following text displays:
Enter Installation Location
OL-4806-01 Rev. A14
Table
The gatekeeper ID must match the entry configured in the gatekeeper.
Table
The E-ISUP host port is typically 8003, but it must match the peer port setting of the IPLNK
object in the PGW 2200 configuration.
The VSCI name is either the DNS host name (if DNS is configured) or the IP address of the
PGW 2200.
Table
The VSCI port is typically 8003, but it must match the port setting of the IPLNK object in the
PGW 2200 configuration.
The installation node ID is a text field typically used by network designers for identification
purposes. Entering a value in this field does not affect functionality.
2-2) and press Enter.
2-2) and press Enter.
2-2) and press Enter.
Table 2-2) and press Enter.
Table 2-2) and press Enter (typically, accept the default platform
Cisco H.323 Signaling Interface User Guide
Installing the Cisco HSI
2-7