Cisco Hsi Installation Information - Cisco Signaling Interface H.323 User Manual

Chapter 2 Installing and Configuring Cisco HSI Software
Step 5 Enter the following command:
# vi .cshrc
Enter the vi insert mode by entering the following command:
Step 6
i (enter insert mode)
Enter the following text on the first line:
Step 7
source /opt/GoldWing/currentPM/local/setup.gw.csh
Save the file and quit vi by entering the following commands:
Step 8
[Esc] (exit insert mode)
:wq (write file and quit)
Enter the following command:
Step 9
# chmod 777 .cshrc

Cisco HSI Installation Information

Gather the information listed in
column in this table to record the information. Several steps in the installation procedure require you to
provide this information. Refer to this table as you proceed through the Cisco HSI installation steps.
Table 2-2
Required Information
Base directory path
Cisco HSI user name
Cisco HSI group name
Gatekeeper IP address
Gatekeeper port
Gateway prefix
Terminal alias
Gatekeeper ID
E-ISUP host port
VSC1
name, if DNS is configured, or the IP
address of the Cisco PGW 2200
VSC1 port
Installation node ID
OL-4806-01 Rev. A14
Table 2-2
Cisco HSI Installation Information
1 2
name (either the DNS host
3
before you begin the Cisco HSI installation. Use the Notes
Notes
We strongly recommend that you accept the
Note
default base directory path.
Default: mgcusr
Default: mgcgrp
Default: 1719
Note This ID must match the entry configured in the
gatekeeper.
Note Typically 8003, but this entry must match the
peer port setting of the IPLNK object in the
PGW 2200 configuration.
)
Typically 8003, but this entry must match the
Note
peer port setting of the IPLNK object in the
PGW 2200 configuration.
Cisco H.323 Signaling Interface User Guide
Installing the Cisco HSI
2-3