Cisco Signaling Interface H.323 User Manual page 46

Cisco HSI Configuration
Table 3-3 Static System Data Parameters (continued)
Parameter
PavoRedirPresInd
CliInDisplaySupported
T38MaxVal
T38Options
AsymmetricHandlingSupported
UseConfID
Cisco H.323 Signaling Interface User Guide
3-6
Type Description
[0-3] The value of the Pavo redirecting number presentation indicator. (If this
parameter is not provisioned, the default is Q.931 zero—no indication.)
STRING If this parameter is present and set to anything other than "", the Calling Number
is also sent in the DISPLAY IE. The NetMeeting endpoint retrieves the calling
party number from the DISPLAY IE in the H.225 setup message. To enable this
parameter, set it to "Enabled."
The T38MaxVal parameter has the following optional attributes that can be
STRING
assigned values in a specific range.
Values for the following attributes must be expressed in hexadecimal
Note
format.
MaxBit—[0x0—0xFFFFFFFF]. Specifies the maximum bit rate in units
•
of 100 bits per second at which a transmitter can transmit or a receiver
can receive T.38 FAX data. The default value is 0x90.
FxMaxBuf—[0x0—0xFFFFFFFF]. Specifies the maximum buffer size
•
for the "t38FaxMaxBuffer" parameter for the T.38 over UDP option. The
default value is 0xc8.
• FxMaxData—[0x0—0xFFFFFFFF]. Specifies the maximum datagram
size for the "t38FaxMaxDatagram" parameter for the T.38 over UDP
option. The default value is 0x48.
This T.38 Fax parameter is assigned one of the following optional values:
STRING
FxFillBit—[0 or 1] The default value is 0.
•
FxTransMMR—[0 or 1] The default value is 0.
•
FxRateTransJBIG—[0 or 1] The default value is 0.
•
FXRate—[Local or Trans] The default value is Trans.
•
FxUdpEC—[Red or FEC] The default value is Red.
•
STRING Asymmetric Codec Treatment support is enabled if this parameter is present and
set to anything other than "". To enable Asymmetric Codec Treatment, set this
parameter to "Enabled."
STRING Use this parameter to specify the precedence of extracting the Global Call ID
from the Conference ID or the GUID in the H.225 Setup message. The
provisioning of this property to a value other than "" gives precedence to the
Conference ID. For example, set it to "Enabled." To set the precedence to the
GUID field, the crafts person can either delete the property from the config or
set it to "".
Chapter 3 Provisioning the Cisco HSI
OL-4806-01 Rev. A14