The DSS configuration utility can disable/enable the analog fax feature
Note
on the MFP. If the analog fax is disabled by the DSS configuration utility
and then the MFP is detached from the configuration utility, you will not
see Send to Fax in the EWS or WJA Digital Sending menu. If this
happens, to enable the analog fax for the MFP, you must use the
DSS configuration utility.
Web browser
As mentioned above, the MFP contains an EWS. The EWS allows
you to use a Web browser to access and set the analog fax settings,
described in this chapter.
To use a Web browser to access the EWS fax setting screens,
perform the following steps.
1
If DSS is being used, a message appears on EWS indicating that DSS
Note
is in control. The only way to change settings is through DSS.
2
3
4
5
HP Web Jetadmin
To access the MFP analog fax settings using HP Web Jetadmin,
perform the following steps. For detailed information on HP Web
Jetadmin, see the HP Web Jetadmin Reference Manual.
1
2
46 Chapter 3 Configuration
Type the IP address of the MFP in the browser URL address bar
and press return to display the EWS Configure MFP screen. To
get the IP address of the MFP, print an MFP Configuration page.
Select the Digital Sending tab.
Select the Send to Fax tab to display the Fax configuration
settings screen.
On the Fax Settings screen make any changes to the settings
and select OK to accept the settings. Select Advanced to display
the Advanced MFP Modem Settings screen for additional fax
settings. For information about the settings, see the setting
descriptions in this guide.
After you have made changes to the settings, select OK to accept
the settings.
Start HP Web Jetadmin.
In the At a Glance text box, type the IP address of the MFP in the
Quick Device Find text box, and then select Go to display the
device status in the right pane. Select Digital Sending and Fax
from the status drop-down menu in that pane.
ENWW