Installing/replacing the fax accessory in the
HP LaserJet 4345mfp
This procedure provides information on how to install the fax card in
the HP LaserJet 4345mfp.
The fax card is installed on the MFP formatter board, which is
accessed by removing a MFP side panel. To install the fax card,
complete the following steps.
1
2
3
4
5
You do not need to remove any cables from the formatter for this
Note
procedure.
MFP formatter cover - HP LaserJet 4345mfp (rear view)
Figure 1-7
8 Chapter 1 Setting up
Unpack the fax card from the box, but do not remove it from its
antistatic pouch.
Set the MFP's power switch to off and disconnect the AC power
cord.
Locate the formatter board (1) on the back of the printer, see
Figure 1-7.
To access the formatter board, locate the removable cover (2) on
the side of the MFP, see Figure 1-7.
Remove the side cover by placing your fingers in the cover's
indented area (2) and pulling, to slide it back and remove it from
the printer.
Rear view
ENWW