6
Formatter cage door - HP LaserJet 4345mfp
Figure 1-8
The fax card contains parts that are sensitive to electrostatic
discharge (ESD). When removing the fax accessory from its antistatic
pouch and while installing it, use static protection, such as a
grounding wrist strap connected to a grounded metal frame of the
MFP or touch the metal frame of the MFP with your hand while
installing the fax card.
If this is the first time the fax is installed, remove the small cover over
Note
the opening for the phone jack on the rear panel of the formatter before
inserting the fax card into the formatter.
If you are replacing an existing fax card, remove the card that is to be
Note
replaced from the formatter.
While handling the fax card, do not press on the yellow component on
CAUTION
the card because this could damage it and cause a fax malfunction.
7
ENWW
Open the formatter cage door (1) by pulling out on the door tab
(2) and swing (3) the door open, see Figure 1-8.
Remove the fax card from its antistatic pouch.
Installing the fax accessory 9