Configuring A Spa Ip Phone For Voice Mail Service - Linksys SPA9000 Administrator's Manual

Configuring a SPA IP Phone for Voice Mail Service

Figure 3-18 SPA400 Administration Web Server—Setup/Voicemail Users Page
If the installation and configuration of the SPA400 was initially performed using the SPA9000
Configuration Wizard, each extension configured for voicemail is populated in the SPA400 Voicemail
Users page.
By default, a user voicemail account is active with the password to access the voicemail account being
identical to their extension (that is, ext.=100 password=100).
Step 2
Verify or modify the settings on the either the SPA400 or SPA900 pages so that each extension of each
SPA900 Series IP phone matches the corresponding settings on the SPA400 Voicemail Users page.
Step 3
If you make any changes, click Save Settings at the bottom of the SPA400 page.
Step 4
If you made any changes to the SPA400 page, click Restart button on the SPA400 page.
The SPA400 device reboots if you save changes.
Configuring a SPA IP Phone for Voice Mail Service
Each valid SPA IP Phone extension configured in the SPA9000 may be configured for voicemail service.
The SPA IP Phone configuration page
Status link in the upper right location of the SPA9000 configuration utility or by directing the browser
to the IP address of the SPA900 Series phone.
Step 1
On the SPA IP Phone administration web server, click the Ext 1 tab.
Figure 3-19
server.
Linksys SPA9000 Administrator Guide
3-18
illustrates the page for Extension 1 on the SPA900 Series IP phone administration web
Chapter 3
(Figure 3-19) can be accessed by either clicking on the PBX
Configuring Voice Service and Voicemail
Document Version 3.01