Initial Setup and Configuration
Entering a Password through the IVR
Note
1.
2.
Initial Setup and Configuration
This section describes how to complete the initial connection and configuration of the SPA9000 system.
It includes the following topics:
•
•
•
•
Linksys SPA9000 Administrator Guide
2-12
To input the password using the phone keypad, the following translation conventions apply:
To input: A, B, C, a, b, c—press "2'
–
To input: D, E, F, d, e, f—press "3'
–
To input: G, H, I, g, h, i—press "4'
–
To input: J, K, L, j, k, l— press "5'
–
To input: M, N, O, m, n, o—press "6'
–
To input: P, Q, R, S, p, q, r, s—press "7'
–
To input: T, U, V, t, u, v—press "8'
–
–
To input: W, X, Y, Z, w, x, y, z—press "9'
–
To input all other characters in the Administrator account password, press "0'
This translation convention only applies to the password input.
For example, to input password test#@1234 by phone keypad, you need to press the following
sequence of digits: 8378001234.
After entering a value, press the # (pound) key to indicate end of input.
–
To save value, press 1.
–
To review the value, press 2.
–
To re-enter the value, press 3.
–
To cancel the value entry and return to the main configuration menu, press
Notes:
The final # key is not included in the password value.
–
Saved settings take effect when the telephone is hung-up, and if necessary, the SPA9000
–
automatically reboots.
After one minute of inactivity, the unit times out. The user needs to re-enter the configuration menu
from the beginning by pressing * * * *.
Licensing, page 2-13
Using DHCP or Static IP Addressing, page 2-13
Using the Wizard for Initial Configuration, page 2-13
Using the Wizard to Upgrade Software, page 2-18
Chapter 2
Getting Started
*
' (star).
Document Version 3.01