Korg KRONOS SGX-2 Parameter Manual page 791

To select two or more items at once, enable the Multiple
Select check-box.
3. Press the Unload button.
A confirmation dialog will appear.
4. Press the OK button to confirm, or Cancel to exit the
dialog without making changes.
Sample data may be shared by two or more Multisamples or
Drum Samples. If a Sample is used only by the Multisample
or Drum Sample being unloaded, the Sample will be
unloaded as well. If the Sample is used elsewhere, it will
stay loaded.
Unloading an entire bank of data
You can also un-load an entire bank of data at once. To do
so:
1. In the menu, select the Unload all in bank command.
The Unload all data from selected bank dialog will appear.
2. Select the desired bank (Sampling Mode, or any EXs
or User Sample Bank).
3. Press the OK button to confirm, or Cancel to exit the
dialog without making changes.
Unloading half of a stereo sound
Stereo Samples and Multisamples are made up of two linked
items, one for the left channel and the other for the right
channel, with names ending in -L and -R respectively. The
left and right channels also may be used individually as
mono sounds.
If either the left or right channel is unloaded, the item is
removed from the list of stereo Samples or Multisamples.
However, the remaining channel is still available as a mono
sound.
Change load method
This button lets you change how the currently selected
sample data is loaded, using either RAM or Virtual Memory.
Note that this has no effect on the data stored on disk.
If all of the selected samples are too large to fit into RAM,
then the Load Method combo box will be grayed out, and
the value will be set to Virtual Memory.
This applies only to data in EXs and User Sample Banks; it
does not apply to Sampling Mode.
Load method [No Change, RAM, Virtual Memory]
No Change: this is the default. The load method of the
sample data will remain as it was before.
RAM: The sample data will be loaded into RAM.
Virtual Memory: The sample data will be loaded using
Virtual Memory.
v 0–4: Page menu commands
• 0: Select all. This command selects all of the items in the
list.
• 1: Unload all in bank. This removes the entire selected
bank from memory. For more information, see
"Unloading an entire bank of data," above, and "Unload
all in bank" on page 824.
• 2: Remap MS/Sample Banks. For more information,
see "Remap MS/Sample Banks" on page 170.
Global P0: Basic Setup 0–4: Sample Management
777