Table of Contents
Advertisement
Effect Guide
138: Cho/Flanger - Multitap Dly
This effect combines a mono chorus/flanger and a multitap
delay.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Chorus/Flanger
+
Chorus/Flanger
EQ
LEQ HEQ
Trim
Feedback
Right
LFO: Tri / Sine
CHORUS/FLANGER
Pre EQ
For detailed information, see "Pre EQ" on page 1003.
139: Phaser - Chorus/Flanger
This effect combines a mono phaser and a chorus/flanger.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Phaser
+
Phaser
Phaser
Resonance
Wet / Dry
Right
LFO: Tri / Sine
PHASER
This is a mono phaser effect. For detailed information, see
"PHASER" on page 1004.
140: Reverb - Gate
This effect combines a mono reverb and a gate.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
EQ Trim
+
Pre Delay
Right
Gate+Dmpr
REVERB
Pre EQ
Trim
Sets the EQ input level.
1016
Multitap Delay
Feedback
Delay
(2)
Cho/Flng
(1)
Mt.Dly
High Damp
Wet / Dry
Wet / Dry
Chorus/Flanger
Chorus/Flanger
Normal
EQ
LEQ HEQ
+
Trim
—
Wet Invert
Feedback
Cho/Flng
Wet / Dry
LFO: Tri / Sine
Reverb
Gate
Reverb
LEQ HEQ
Reverb
Balance
Input Reverb Mix
Input
Envelope - Control
D-mod
Envelope Select
Gate
[0...100]
LFO and FLANGER
This effect can produce either chorusing or flanging,
depending on the settings. For detailed information, see
"CHORUS/FLANGER" on page 1003.
Wet / Dry
Note: Unlike the other Mono-Mono Serial effects, this
Chorus/Flanger does not include modulation of Wet/Dry.
MULTITAP DELAY
For detailed information, see "MULTITAP DELAY" on
Wet / Dry
page 1002.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 904.
CHORUS/FLANGER
Pre EQ
Wet / Dry
For detailed information, see "Pre EQ" on page 1003.
LFO and FLANGER
This effect can produce either chorusing or flanging,
Output Mode
depending on the settings. For detailed information, see
"CHORUS/FLANGER" on page 1003.
Wet / Dry
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 904.
LEQ Fc
Selects the cutoff frequency (low or mid-low) of the low-
range equalizer.
Wet / Dry
LEQ Gain [dB]
Sets the gain of the Low EQ.
HEQ Fc
Wet / Dry
Selects the cutoff frequency (high or mid-high) of the high-
range equalizer.
HEQ Gain [dB]
Sets the gain of the High EQ.
REVERB
Pre Delay [msec]
Sets the delay time of the reverb sound and gate control
signal.
[Low, Mid-Low]
[–15.0...+15.0]
[High, Mid-High]
[–15.0...+15.0]
[0...200]
Advertisement
Table of Contents
