Table of Contents
Advertisement
EXi: EP-1 MDS Electric Piano
Wet/Dry
Sets the balance between the "wet" processed sound and the
dry input. The default is Wet.
Note: When Mode is set to Chorus, the Intensity control is
the same as Wet/Dry.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
EP Chorus
This is inspired by a rare chorus built into an early version of
a famous modified tine piano.
Speed [Hz]
This controls the speed of the chorus' LFO. The default is
1.96 Hz.
Source
This selects a modulation source to control the Speed. For a
list of Dmod sources, see the "Dynamic Modulation Source
List" on page 1118.
Amount
This controls the depth and direction of the Speed
modulation.
Depth
This sets the depth of LFO modulation. The default is 55.
Source
This selects a modulation source to control the Depth.
Amount
This controls the depth and direction of the Depth
modulation.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 418.
Vintage Flanger
A model of a truly classic analogue flanger. This amazing
stompbox's bucket-brigade technology provides a sweeping,
whooshing sound, perfect for chords.
Speed [Hz]
This controls the speed of the LFO. The default is 0.14Hz.
Source
This selects a modulation source to control the Speed. For a
list of Dmod sources, see the "Dynamic Modulation Source
List" on page 1118.
Amount
This controls the depth and direction of the Speed
modulation.
Depth
Sets the depth of LFO modulation. The default is 71.
420
[Dry, 1: 99...99:1, Wet]
[List of Dmod Sources]
[–100...+100]
[0.10...10.00]
[List of Dmod Sources]
[–10.0...+10.0]
[0...100]
[List of Dmod Sources]
[–100...+100]
[0.10...10.00]
[List of Dmod Sources]
[–10.0...+10.0]
[0...100]
Source
This selects a modulation source to control the Depth.
Amount
This controls the depth and direction of the Depth
modulation.
Resonance
This controls the intensity of the flanger effect, via feedback.
The default is 35.
Manual
This adjusts the offset of the LFO sweep, effectively
increasing the center delay time of the chorus. The default is
35.
When Depth is set to the maximum of 100, this has no
effect.
Source
This selects a modulation source to control the Manual
amount.
Amount
This controls the depth and direction of the Manual
modulation.
LFO Reset Source
This selects a modulation source to reset the LFO. You can
use this to re-start the flanger's jet-like, rolling motion just
before a big power chord, for instance. This will be most
useful when the Speed is set relatively low.
Reset Offset Amount
This controls the phase of the LFO when reset.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
"OUTPUT" on page 418.
Red Compressor
Need to play clean chordal passages with smooth, even
dynamics? Then, look no further: this compressor is
modeled on a pedal whose clean sound made it hugely
popular. Perfect for pop and funk music.
Sensitivity
This controls the amount of compression. Increasing the
value boosts lower level sounds, and raises the overall
volume. The default is 50.
To adjust the final volume, use the Output Level parameter.
Attack
This controls the onset time of the compressor. The default is
25.
Level
Compression reduces the overall gain of the signal. This
allows you to compensate for that effect, by boosting the
gain again at the output. The default is 50.
[List of Dmod Sources]
[–100...+100]
[0...100]
[1...100]
[List of Dmod Sources]
[–100...+100]
[List of Dmod Sources]
[0...100]
[1...100]
[1...100]
[0...100]
Advertisement
Table of Contents
