Removing And Replacing The Side Access Panel And Metal Side Cover; Removing The Side Access Panel - HP t610 Series Hardware Reference Manual

8. Install the stand, if you will be using the thin client unmounted in a vertical orientation. See
Installing the stand on page 4
9. Reconnect any external devices and power cords.
10. Turn on the monitor, the thin client, and any devices you want to test.
11. Load any necessary drivers.
NOTE:
eng/support.html.
12. Reconfigure the thin client, if necessary.
Removing and replacing the side access panel and
metal side cover

Removing the side access panel

WARNING!
power cord is disconnected from the electrical outlet.
To remove the left or right access panel:
1. Remove the stand, if it is installed. See
2. Press the tab on the bottom cover (1), and then slide the cover back (2) and lift it off the chassis.
Figure 2-1
3. Lay the thin client on its side on a secure working surface.
●
Remove the right side access panel to remove or install a SODIMM.
●
Remove the left side access panel to:
◦
◦
for more information.
You can download select hardware drivers from HP at
Before removing the side access panel, ensure that the thin client is turned off and the
Removing the bottom cover
Remove or replace the battery
Install or remove a flash memory module

Removing and replacing the side access panel and metal side cover

Removing the stand on page 5
http://www.hp.com/country/us/
for more information.
11