Resuming Operation (Recovery From Sleep Or Hibernation Mode); Precautions - Panasonic CF-S10 Series Operating Instructions Manual

Sleep/Hibernation Functions
1
Click
[System and Security] - [Change
what the power buttons do].
2
Change the setting in [When I
press the power button] and
click [Save].
Closing the Display
When closing the display, the computer will enter
either the sleep or hibernation mode, depending on
the setting. (At the time of purchase, the computer is
set to go into sleep mode.)
When entering the sleep or hibernation mode, close
the display correctly. If you do not (for example, if
you open the display soon after you close it), the
computer may not enter sleep or hibernation mode.
•
Changing the setting
You can change the setting so that instead of
entering sleep, the computer enters hibernation,
shuts down or does nothing.
If [Do nothing] is set, the computer does not enter
sleep or hibernation.
1
Click
[System and Security] - [Change
what the power buttons do].
2
Change the setting in [When I
close the lid] and click [Save].
Resuming Operation (Recovery
from sleep or hibernation mode)
Use any of the following methods to resume from
standby or hibernation mode.
In the default settings, the Windows password of the
logged on user account must be entered when the
computer resumes from sleep or hibernation.
Using the Power Switch
40
(Start) - [Control Panel] -
(Start) - [Control Panel] -
Power Switch/
Power Indicator
Opening the Display
In the following cases, the computer resumes when
the display is opened.
•
If the display was closed after [When I close the
lid] is set to [Sleep] or [Hibernate].
•
If the display was closed after the computer enters
sleep or hibernation
If you do not want the computer to resume, slide the
power switch.
NOTE
•
If the computer enters sleep while a USB
keyboard or mouse is connected, touching the
USB keyboard keys or mouse will resume the
computer.
For detailed information, refer to
Manual " (Using Let'snote)".
•
Do not perform the following operations until
resuming is complete. After the display is
resumed, wait approximately 15 seconds
(normally) or 60 seconds (when the computer is
on a network).
•
Shut down or restart Windows.
•
Enter sleep or hibernation.
CAUTION
When [Password On Resume] is set to [Enabled]
or [Auto] in the [Security] menu of Setup Utility,
the supervisor password or user password must
be entered when the computer resumes from
sleep or hibernation.
After 3 wrong password attempts have been
made or there is no input for one minute, the
following actions apply.
(At this time, the power switch cannot be turned
off.)
•
Failed after resuming from hibernation:
•
Even if the [Panasonic] boot screen is displayed
at the next startup, do not start the Setup Utility
to change the settings. The computer may not
resume correctly from the next time.
•
The computer can no longer be resumed by
opening the display or using the LAN Wake Up
function or task scheduler.
•
Failed after resuming from sleep:
The computer can no longer be resumed using
USB devices.

Precautions

Read Reference Manual "
carefully before performing sleep, hibernation and
resume operations.
Reference
(Using Let'snote)"