Shutting Down (Power Off Your Computer); When You Leave The Computer Or Interrupt Your Work - Panasonic CF-S10 Series Operating Instructions Manual

Shutting Down (power off your
computer)
1
Save necessary data and close
each application.
2
Power off your computer.
When using the touch pad.
1 Click
(Start).
2 Click [Shut down].
Your computer will power off automatically.
Restarting your computer (without shutting
down): click
When using the keyboard.
1 Press
, , and click [Shut down].
2 Press
.
You can display the shutdown screen by
pressing +
3
Close the display only after
confirming the power indicator is
not lit.
•
Battery Charge Retention Times
Battery Type
Approx. 7 days (If "LAN Wake Up function" is
enabled: 5 days)
In sleep
(When all power has been consumed in sleep mode, all data is lost.)
Approx. 40 days (If "LAN Wake Up function" is
In hibernation
enabled: 10 days)
When power Approx. 40 days (If "Power On by LAN" is
is off enabled: 10 days)
Even if "LAN Wake Up function" is enabled, the battery will discharge at a slightly slower rate if the LAN cable is
not connected.
For detailed information, refer to
- [Restart].
.
Battery Pack
Reference Manual "
CAUTION
•
Do not do the following during the shutdown
procedure.
•
Connecting or disconnecting the AC adaptor.
•
Touching the power switch.
•
Performing any keyboard, touch pad or external
mouse operations.
•
Closing the display.
•
Sliding the drive power/open switch.
•
Once the computer is powered off, you must wait
at least ten seconds before powering it on again.
•
If you will not use for a long time
•
To save power, turn off the computer and
disconnect the AC adaptor from the power
outlet (if you leave the computer connected
to the power outlet, the AC adaptor itself will
consume up to 0.3 W of power).
•
Note that the computer consumes electricity
even when the computer is turned off. If you
have not used the computer for a long time,
charge the battery pack before the next use, or
use the AC adaptor.
The battery charge retention times are shown in
the table below.
When you leave the computer
or interrupt your work...
If you use the "Sleep" or "Hibernation" function,
then when you turn on the power next time, the
software application and files you were using
before will be displayed, and you can restart the
same operations. (  page 38)
•
Press + to put your computer in the
sleep mode.
•
Press + to put your computer in the
hibernation mode
•
Slide the power switch to resume from the sleep/
hibernation mode.
Lightweight Battery Pack
Approx. 3.5 days (If "LAN Wake Up function"
is enabled: 2.5 days)
Approx. 20 days (If "LAN Wake Up function" is
enabled: 5 days)
Approx. 20 days (If "Power On by LAN" is
enabled: 5 days)
(Using Let'snote)"
27