Reinstalling - Panasonic CF-S10 Series Operating Instructions Manual

Troubleshooting

Reinstalling

CAUTION
Do not interrupt the reinstallation procedure
before completion, for example by turning off
the computer, as this may prevent Windows from
starting up, or may cause data to be lost so that
the reinstallation procedure cannot be executed.
1
Back up important data to a
location other than the hard disk
(an external hard disk or other
media).
When reinstallation procedure is performed,
the contents of the hard disk will be erased.
•
If you have created partitions for data, the
data may be erased or become corrupt
as a result of an unexpected malfunction,
incorrect operation, or other reason.
2
Make a note of the network's
settings.
When reinstallation procedure is performed,
the network's settings will be erased.
3
Make a note of your user name
and password.
When reinstallation procedure is performed,
your user name and Windows password will be
erased.
4
Turn off the computer, and
connect the AC adaptor.
5
Turn on the computer, and press
or
boot screen is displayed to start
up the Setup Utility.
Press
82
Reinstalling Software
while [Panasonic]
F2
Press
or Del
•
If the [Panasonic] boot screen is not
displayed, turn on the computer while
holding down
or until the Setup Utility screen or
password input screen appears.
•
When the password is set, [Enter Password]
will be displayed. Enter supervisor
password, and press
Enter Password
You cannot set default settings (except the
password, System Time and System Date)
with a User Password.
•
If you change the settings from that at the
time of purchase, we recommend that
you make a note of the settings that are
changed.
6
Press .
7
At the confirmation message,
select [Yes] and press
Load Optimized Defaults
Load Optimized Defaults?
Yes No
8
Press , and then select [Yes]
at the confirmation message and
press .
The Setup Utility will close, and the computer
will restart.
If the password has been set, enter the
Supervisor Password, and press
or . Hold down
.
F9
Press
.
.