Entering The Sleep Or Hibernation Mode - Panasonic CF-S10 Series Operating Instructions Manual

6
Click [Change advanced power
settings].
7
Double-click [Sleep].
Here, you can also select a power plan to
check or change the time until the computer
enters hibernation.
8
Double-click [Hibernate after].
9
Click an item, and check or
change the time until the
computer enters hibernation.
•
We recommend setting a time longer
than the default setting (1080 minutes).
If a shorter value is set, the frequency of
transition from sleep to hibernation will
increase. Because data is written onto
the hard disk when transitioning between
statuses, the computer may be exposed to
vibration when being carried, resulting in a
malfunction. If you set a shorter value, do
not carry around the computer.
•
To stop the computer from entering
hibernation, set the time until entering
hibernation to [Never].
10
Click [OK].
NOTE
You can set the time until sleep and hibernation is
entered separately for each power plan.
Entering the Sleep or Hibernation
Mode
Use any of the following methods to enter the sleep
or hibernation mode.
It may take approximately 1 to 2 minutes for the
computer to enter hibernation. Nothing is displayed
on the screen, but wait and do not perform any
operations.
CAUTION
•
The computer may enter the hibernation mode
by thermal control if you use the computer
in a high ambient temperature and use an
application that uses a lot of CPU power.
Wait a few minutes (at least 5) before turning
the computer on again if this occurs.
Using
Setting to
While pressing
sleep
Setting to
While pressing
hibernation
Using the shutdown screen
Click (Start) - and click [Sleep] or [Hibernate].
Using the power switch
If you continue to slide the power switch and hold it
for more than four seconds, the computer will power
off. Data not previously saved will be lost.
Because the power-saving function is set, there is no
beep when you slide the power switch.
If you want the beep to sound, refer to
Troubleshooting.
Even if the beep is set to sound, when the speaker
function is disabled, for example by pressing
, there will be no beep sound. Pressing
will lower the beep sound.
•
Changing the setting
You can change the setting so that instead of
entering sleep, the computer enters hibernation,
shuts down or does nothing.
If [Do nothing] is set, the computer does not enter
sleep or hibernation.
F7
Fn , press
F10
, press
Fn
Slide the power switch
and hold it for one
second; release your finger.
Do not touch the power
switch until the power
indicator goes off or blinks.
+
+
39