Panasonic CF-S10 Series Operating Instructions Manual page 59

Setting the Hard Disk Lock
When the [Hard Disk Lock] is set to [Enabled], it is impossible to read/write data from/to the hard disk
when the hard disk is inserted in a different computer.
Note that this Hard Disk Lock does not guarantee complete protection of data.
1
Start up the Setup Utility. (
If the password has been set, enter the Supervisor Password, and press
When the Supervisor Password has not been set, set the Supervisor Password. (  below)
2
Select [Security] using
To set the supervisor password:
1 Select [Set Supervisor Password] using
2 Enter your password in [Create New Password] and press
3 Enter your password again in [Confirm New Password] and press
3
Select [Hard Disk Lock] using
4
Select [Enabled] using
5
At the confirmation message, press
6
Press , and then select [Yes] and press
When starting up the computer, if the message [Hard disk access is prohibited by "Hard Disk Lock"]
appears, run the Setup Utility, and change the settings to match the details when [Hard Disk Lock] was
set.
page 57)

or .
or , and press
or , and press
or , and press
.
.
.
.
.
.
.
.
59