Suspend/Hibernation Functions - Panasonic CF-27 series Reference Manual

Suspend/Hibernation Functions

Starting Up Your Computer Quickly
If you want to immediately start up and continue an application after shutting down your
computer, you can do so by using the suspend or hibernation function.
NOTE
With Windows 98, the "Suspend" is called "Standby".
Differences between the suspend and hibernation functions
Function Suspend function
Where data is saved to Memory
Speed Fast
Requires power supply Yes
Setting the Suspend or Hibernation Function
[Off] is factory set.
1
Run the Setup Utility
2
Using and
3
Using and
4
Using and
Enter
5
Press F10 , then select [Yes]
Shutting Down Using the Suspend or Hibernation Function
The computer should be set for suspend or hibernation (
dure).
Slide the power switch
(After releasing your finger from the
power switch, do not touch the power
switch, keyboard or pointing device while
the computer is entering in the suspend
or hibernation modes.)
CAUTION
At the "beep*" sound, release your finger from the power switch. If you con-
tinue to slide the switch and hold it for more than four seconds, the "beep*" will
sound again and the power will go OFF. Data not previously saved will be lost.
Slide the power switch to power on.
If the computer will not be operated for an extended period of time, it is recom-
mended that hibernation mode be used instead of the suspend mode.
*
When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the Setup
Utility ( page 41) or by the key combination Fn + F4 , there will be no beep sound.
(if power is cut, all data is lost)
( page 41)
, select [Power]
, select [Power Switch] and press Enter
, select [Suspend] or [Hibernation] and press
Hibernation function
Hard disk
Somewhat slow
Power is not required to maintain data
see the above proce-
Suspend Mode
or
Hibernation Mode
12