Standby/Hibernation Functions - Panasonic CF-07 Series Reference Manual

Standby/Hibernation Functions

Starting Up Your Computer Quickly
Entering the Standby or Hibernation mode
If you want to immediately start up and continue an application after shutting down your
computer, you can do so by using either the standby or hibernation function.
Differences between the standby and hibernation functions
Function Where data is saved to
Standby Memory
function
Hibernation Hard disk
function
NOTE
We recommend plugging in the AC adaptor if the standby function is to be
used for a long period of time. If the AC adaptor cannot be connected, we
recommend that hibernation mode be used instead of the standby mode.
If the standby or hibernation function is used repeatedly, the computer may
not work properly. To stabilize computer operations, we recommend shutting
down Windows on a regular basis (about once a week) without using the
standby or hibernation function.
Use any of the following methods to enter the standby or hibernation mode.
To use the hibernation mode, make the setting below in advance. (Enabled in factory
preset.)
Using the power switch (
From the shut down screen:
• Standby
In [Start] - [Turn Off Computer], select [Stand By].
• Hibernation
In [Start] - [Turn Off Computer], select [Hibernate].
To perform this operation, make the setting as follows in advance;
Select [Start] - [Control Panel] - [User Accounts] - [Change the way users log on or
off] and delete the check mark for [Use the Welcome screen].
Setting for using the hibernation mode
1 Select [Start] - [Control Panel] - [Performance and Maintenance] - [Power Op-
tions].
2 In [Hibernate], add the check mark for [Enable hibernation] and select [OK].
Speed Requires power supply
Fast Yes (if power is cut, all data is lost)
Somewhat Power is not required to maintain data
slow
page 5)
3
(To next page)