Graco LineDriver Operation, Repair, And Parts page 52

Parts / Pièces / Piezas / Delen / Teile
Safety Interlock Wiring Diagram / Schéma de verrouillage /
Diagrama de cableado de interbloqueo de seguridad /
Bedradingsschema beveiligingssysteem /
Schaltplan für Sicherheitsverblockung
Maintenance / Entretien / Mantenimiento / Onderhoud / Wartung
English
Interval
DAILY
AFTER THE FIRST 20 HOURS OF
OPERATION
WEEKLY
EVERY 100 HOURS OF OPERATION
YEARLY OR 500 HOURS
SPARK PLUG
52
10
123
120
Check engine oil level and fill as necessary.
Check hydraulic oil level and fill as necessary.
Check and fill the gas tank.
Drain engine oil and refill with clean oil.
Reference Engine Owner's Manual for correct oil viscosity.
Remove engine air filter cover and clean or replace element. If operating in an unusually dusty
environment: check filter daily and replace, if necessary.
Replacement elements can be purchased from your local dealer.
Change engine oil. Reference Engine Owner's Manual for correct oil viscosity.
Replace hydraulic oil and filter element. Use Mobil 1 (15W-50) synthetic oil and Graco filter
245342.
Hydraulic Oil Replacement Procedure:
1. Remove filter and allow oil reservoir to drain from filter base.
2. Install new filter. Fill oil reservoir to top of baffle with Mobil 1 (15W-50).
3. Open drive wheel release. Start engine and run at low rpm for 3 minutes.
4. Close drive wheel release. Check oil level and top off to top of baffle.
Use BPR6ES (NGK) or W20EPR-U (NIPPONDENSO) plug. Gap plug to 0.028 to 0.031 in. (0.7
to 0.8 mm).
121
37
Action
122
ti10939a