Warnings - Graco LineDriver Operation, Repair, And Parts

Warnings

The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks.
When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings.
Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this
manual where applicable.
TRAFFIC HAZARD
Being struck by other vehicles may result in serious injury or death.
Do not operate in traffic.
•
Use appropriate traffic control in all traffic areas.
•
Follow local highway and transportation regulations for traffic control (for example: Manual on
•
Uniform Traffic Control Devices, U.S. Department of Transportation).
MOVING VEHICLE HAZARD
Careless and reckless behavior causes accidents. Falling from vehicle, running into people or object, or
being struck by other vehicles may result in serious injury or death.
Do not step on forward/reverse pedals.
•
Make turns slowly. Do not make turns greater than 45°.
•
Loss of traction may occur going downhill. Do not operate on slopes greater than 15°.
•
Do not carry passengers.
•
Do not tow.
•
Use with line striping equipment only.
•
Use appropriate traffic control in all traffic areas. Refer to manual on Uniform Traffic Control Devices
•
(MUTCD), U.S. Department of Transportation, Federal Highway Administration or local highway and
transportation regulations.
FIRE AND EXPLOSION HAZARD
Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help
prevent fire and explosion:
Use equipment only in well ventilated area.
•
Do not fill fuel tank while engine is running or hot; shut off engine and let it cool. Fuel is flammable
•
and can ignite or explode if spilled on hot surface.
Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and plastic drop
•
cloths (potential static arc).
Keep work area free of debris, including solvent, rags and gasoline.
•
Do not plug or unplug power cords, or turn power or light switches on or off when flammable fumes
•
are present.
Ground equipment and conductive objects in work area. See Grounding instructions.
•
Use only grounded hoses.
•
Hold gun firmly to side of grounded pail when triggering into pail.
•
If there is static sparking or you feel a shock, stop operation immediately. Do not use equipment
•
until you identify and correct the problem.
Keep a fire extinguisher in work area.
•
WARNING
Warnings
3