Product Hardware Features - TRENDnet TEG-204WS User Manual

TRENDnet User's Guide

Product Hardware Features


Reset Button – Press and hold the button 1~5 seconds and release to
reboot the device. Pressing the button more than 6 seconds will reset
the switch to factory defaults. The ports LEDs will turn off to indicate
that the reset was initiated.

Gigabit Ethernet Ports (1-20) – Connect network devices. Ports 17-20
are shared with SFP slots 17F-20F and are disabled when SFP slots (17F-
20F) are in use.

SFP Slots (17F-20F) – Supports optional 1000BASE-SX/LX mini-GBIC
modules for uplink or downlink connections.
© Copyright 2017 TRENDnet. All Rights Reserved.
Front View
Rear View
Diagnostic LEDs

Power LED
On : When the Power LED is on, the device is receiving power.
: When the Power turns off, the power cord is not
Off
connected or the device is not receiving power.

Gigabit Ethernet Port LEDs (1-20)

Link/Activity
Green : When the Green LED is on, the respective port is
on connected to a 1Gbps Ethernet network.
: When the Green LED lights on, the respective port is
Amber
on connected to a 10/100Mbps Ethernet network.
Green : When the LED is blinking green, the port is transmitting or
Blinking receiving data on the network at 1Gbps speed.
: When the LED is blinking amber, the port is transmitting
Amber
Blinking or receiving data on the network at 10/100Mbps speed.
Off When the LED is off, the respective port is disconnected.
TEG-204WS
2