Product Hardware Features - TRENDnet TPE-30102WS User Manual

TRENDnet User's Guide

Product Hardware Features

Rear View
Smart Fans

AC Power Connector – Connect the AC power cord to the connector and the
other side into a power outlet. (Input: 100~240VAC, 50/60Hz)
Front View
Console Port
Reset
LED Indicators
Button

Smart Fan – Smart fans will automatically adjust speed based on
temperature and switch usage. The smart fans are hot swappable.
© Copyright 2018 TRENDnet. All Rights Reserved.
AC Power Connector
2.5G/1G/100M
PoE+ Ports
10G
SFP+
Slots

Reset Button – Press and hold this button for 10 seconds and release to
reset the switch to factory defaults. The System LED will flash rapidly
(orange) and turn solid (orange) to indicate the reset procedure was
successful.

Console Port – Connect the included RJ-45 to RS-232 cable access the
command line interface. The command line management interface does
not provide full command line management access to all features, only
basic features such as modifying the administrator password and switch
IP address.

Reset Button – Press and hold this button for 10 seconds and release to
reset the switch to factory defaults. The System LED will flash rapidly
(orange) and turn solid (orange) indicating the reset procedure was
successful. If using the hardware reset button to reset to factory default,
the system LED will remain orange until the first device reboot.

2.5 Gigabit PoE+ Ports (1-8) – Connect network devices at
2.5G/1G/100M speeds.

SFP+ slots (9-10) – Supports optional 10G SFP+ mini-GBIC modules.
TPE-30102WS
2