Table of Contents
Advertisement
TRENDnet User's Guide
Basic Installation
3. Assign a static IP address to your computer's network adapter in the subnet of
192.168.10.x (e.g. 192.168.10.25) and a subnet mask of 255.255.255.0.
4. Open your web browser, and type the IP address of the switch in the address bar, and
then press Enter. The default IP address is 192.168.10.200.
5. Enter the User Name and Password, and then click Login. By default:
User Name: admin
Password: admin
Note: User name and password are case sensitive.
© Copyright 2017 TRENDnet. All Rights Reserved.
6. Click System and then click IPv4 Setup.
7. Configure the switch IP address settings to be within your network subnet, then click
Apply.
Note: You may need to modify the static IP address settings of your computer's network
adapter to IP address settings within your subnet in order to regain access to the switch.
5. In the left hand panel, click Tools, click on Configuration, and click Save.
6. Click Save Settings to Flash, then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-204WS
5
Advertisement
Table of Contents
