Table of Contents Table of Contents English ... 1. Before You Start 2. Hardware Installation ... 3. Web Management Utility ... Troubleshooting ... Version 04.28.2006...
1. Before You Start System Requirements Web Browser: Internet Explorer (5.0 or above), Netscape (6.0 or above) Computer with Network adapter installed Application 26-Port 10/100/1000Mbps Gigabit Web Smart Switch (TEG-224WSplus) Workstations with 10/100Mbps Ethernet Card (TE100-PCIWN) 1000Mbps TEG-224WSplus Quick Installation Guide Utility CD-ROM 2 mounting brackets with screws AC Power Cord...
2. Hardware Installation 1. Connect the Power Cord to the rear of the TEG-224WSplus and then to a power outlet. 2. Connect a CAT-5 network cable from the computer to an available Ethernet port of the TEG-224WSplus. English...
3. Web Management Utility Note: Install and use the Web Management Utility to discover all the Web Management Switches on the network, assign IP Address, change the password, and upgrade to new firmware. For Windows User 1. Insert the Utility CD-ROM into your computer's CD-ROM Drive and then click Install Utility.
Page 6
4. Click Discovery, and then double- click the Switch that appears in the Discovery List. 5. Click the Switch in the Monitor List and then click Configuration setting. 6. Configure the IP Address, Subnet mask, Gateway, and Password. Click Set. English...
Page 7
8. Click Web access. 9. Type in your Password and then click Login. For more information regarding the TEG-224WSplus configuration and advanced settings, please refer to the User's Guide included on the Utility CD- ROM or TRENDnet's website at www.trendnet.com English...
Also make sure to use a CAT-5e or CAT- 6 Ethernet cable. If you still encounter problems or have any questions regarding the TEG-224WSplus, please refer to the User's Guide included on the Utility CD-ROM or contact TRENDnet's Technical Support Department.