Enable And Configure Lldp - TRENDnet TEG-204WS User Manual

TRENDnet User's Guide

Enable and configure LLDP

Link Layer Discovery Protocol (LLDP) allows Ethernet network devices, such as switches
and routers, to receive and transmit device-related information to directly connected
devices on the network and to store data that is learned about other devices.
Network > LLDP > Settings
1. Log into your switch management page (see
on page 7).
2. Click on Network, click on LLDP, and click on Settings.
3. Review the settings.
Enabling or Disabling LLDP

From the LLDP parameter, select one of the following radio button choices and
click Apply to save the settings.

Enable: The LLDP feature is active.

Disable: The LLDP feature is inactive.
Configure the LLDP Parameter Settings
Message TX Hold Multiplier: Sets the hold multiplier value. The hold time multiplier is
multiplied by the transmit interval to give the Time To Live (TTL) that the switch
advertises to the neighbors. The range is from 2 to 10.
Message TX Interval: Sets the transmit interval, which is the interval between regular
transmissions of LLDP advertisements. The range is from 1 to 10 seconds.
LLDP Reinit Delay: Sets the reinitialization delay, which is the number of seconds that
must elapse after LLDP is disabled on a port before it can be reinitialized. The range is
from 1 to 10 seconds.
© Copyright 2017 TRENDnet. All Rights Reserved.
"Access your switch management page"
LLDP TX Delay: Sets the value of the transmission delay timer, which is the minimum
time interval between transmissions of LLDP advertisements due to a change in LLDP
local information. The range is from 1 to 8192 seconds.
Click Apply to save the settings.
TEG-204WS
59