Product Hardware Features - TRENDnet TI-PG1284i User Manual

TRENDnet User's Guide

Product Hardware Features

© Copyright 2016 TRENDnet. All Rights Reserved.
LED Indicators
LED State Status
PWR When the PWR LED is on, the device is using the primary
ON
power input source.
(Green)
Primary power input source is off, disconnected, or has
OFF
failed.
RPS When the RPS LED lights on, the device is using the
ON
redundant power input source.
(Green)
Redundant power input source is off, disconnected or has
OFF
failed.
ALM
Indicates alarm has been triggered on DIP switch settings and
ON
signal sent out through ALM terminals on terminal block to
(Red)
third party alarm device.
OFF No alarm triggered.
POST ON Device is ready and completed boot process.
(Green)
OFF Device is not ready.
SFP Slots 9-12 ON SFP link is connected.
(Green)
BLINKING Data is transmitting/receiving.
OFF SFP link is disconnected.
PoE Ports 1-8 ON PoE supplied to Ethernet port.
(Green)
OFF No PoE supplied to Ethernet port.
Ports 1-8
ON Ethernet port is connected.
1000M
(Green)
BLINKING Data is transmitting/receiving.
10/100M
(Orange) OFF Ethernet port is not connected.

Ports 1-8 – Designed to operate at 10Mbps, 100Mbps, or Gigabit speed in both
half-duplex and full-duplex transfer modes. Supports Auto MDI-X and capable
of delivering up to 30W (802.3at PoE+) per port.

SFP Slots 9-12 – Designed to operate at Gigabit speeds.

Reboot Button – Push the button and release to reboot the switch.

Grounding point/screw – The switch chassis can also be connected to a known
ground point for additional safety and protection. (grounding wire not
included)
Note: For any unused ports or SFP slots, it is recommended to leave the rubber plugs
installed during operation.
TI-PG1284i
3